NEW, an intelligent connection box for industrial weighing systems.
Interference's
are a source of annoyance, cause business interruption or disturb your process,
so they cost money. That means a quick remedy is a must. The new PENKO cable
connection box type SJB190 helps you doing so. Every load cell, up to four per
weighing system, is monitored individually. Deviations outside the pre-set
tolerances are made visible on the display and reported via a potential-free
contact.
On the
front of the instrument you find a clear OLED display, good visible under sunny
circumstances, with control buttons. This allows fault finding by checking the
measurement signal of each load cell separately by simultaneously comparing it
with the average of all sensors and the excitation voltage. You localise
immediately without searching whether, for example, a cable is broken, a load
cell drifts or was overloaded. If necessary, you can take preventive action and
replace the defective sensor.
This
intelligent connection box replaces the usual one, since no external power
supply is required. Delivery takes place optionally in a robust plastic (IP65)
or stainless steel (IP66) housing, both suitable for wall mounting.
